IKEA LAGAN-N Manuel d'utilisateur télécharger pdf (Page 16)

If there are other fuel burning appliances in

the same room, B.S. 5440 Part 2 Current

Edition, should be consulted to determine

the requisite air vent requirements.

For appliances installed in the Republic of

Ireland please refer to the NSAI- Domestic

Gas Installation I.S. 813 Current Editions

Table Four.

Location

The hob may be located in a kitchen, a

kitchen/diner or bed sitting room (with a

volume greater than 20 m³), but not in a

bathroom or shower room.

The minimum distance combustible material

can be fitted above the hob in line with the

edges of the hob is 400 mm. If it is fitted

below 400 mm a space of 50 mm must be

allowed from the edges of the hob.

For appliances installed in the Republic of

Ireland please refer to NSAI- Domestic Gas

Installation I.S 813 Current Edition Section

7- Permitted Locations of Appliance.

Electrical connection

Warning! Refer to Safety

chapters.

Connection cable

Caution! Information for

authorised installer only.

Warning!

The appliance must be earthed.

Warning!

Risk of injury from electrical

current.

• The electrical mains terminal is under

voltage.

• Make sure that the electrical mains

terminal is free of voltage.

• Loose and inappropriate plug and

socket connections. May overheat the

terminal.

• Make sure that the clamping connections

are installed correctly.

• Secure the cable with the strain relief

clamp.

Before connecting, check that the nominal

voltage of the appliance stated on the

rating plate, corresponds to the available

supply voltage. Also, check the power

rating of the appliance and make sure that

the wire is suitably sized to suit the

appliance power rating. Refer to the

Technical data chapter.

Electrical Requirements

Permanent electrical installation must

comply with the latest I.E.E. Regulations and

local Electricity Board regulations. For your

own safety the installation must be done by

a qualified electrician (e.g. your local

Electricity Board, or a contractor who is on

the roll of the National Inspection Council

for Electrical Installation Contracting

[NICEIC]).

You can check the parameters of

adjustment setting for this

appliance on the rating plate.

Refer to the Technical data

chapter.

The manufacturer declines any

liability if these safety measures

are not observed.

ENGLISH 16

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Commentaires sur ces manuels

Pas de commentaire