IKEA DAGLIG Manuel d'utilisateur télécharger pdf (Page 14)

If you operated the appliance

wrongly, or the installation was

not carried out by a registered

engineer, the visit from the After

Sales Service technician or

dealer may not take place free

of charge, even during the

warranty period.

Installation

General information

Manufacturer is not responsible for any

injury to persons and pets or damage to

property caused by failure to comply

following requirements.

Caution! To proceed with the

installation refer to the assembly

instructions.

Warning! Installation process

must follow the laws, ordinances,

directives and standards

(electrical safety rules and

regulations, proper recycling in

accordance with the regulations,

etc.) in force in the country of use!

Warning! The appliance must be

earthed!

Warning! Risk of injury from

electrical current.

• The electrical mains terminal is live.

• Make electrical mains terminal free of

voltage.

• Loose and inappropriate plug and

socket connections can make the

terminal overheat.

• Have the clamping connections correctly

installed.

• Use strain relief clamp on cable.

• Follow the connection diagram (it is

located on the underneath surface of the

casting of the hob).

Important!

• You must observe the minimum distances

to other appliances and furniture

cabinets or other units according to

Assembly Instruction.

• If there is no oven beneath the hob insert

a dividing panel at a minimum distance

of 20 mm from the bottom of the hob.

• Do not use silicon sealant between the

appliance and the worktop. Avoid

installing the appliance next to doors

and under windows as hot cookware

may be knocked off the rings when doors

and windows are opened.

• Only an authorized service engineer can

install, connect or repair this appliance.

Use only original spare parts.

Electrical connection

• Before connecting, check that the

nominal voltage of the appliance stated

on the rating plate, corresponds to the

available supply voltage. Also, check the

power rating of the appliance and

ensure that the wire is suitably sized to

suit the appliance power rating (refer to

the Technical information chapter). The

rating plate is located on the lower

casing of the hob.

• The appliance is not provided with mains

cable. Buy the right one from specialized

dealer. Single-phase or two-phase

ENGLISH

14

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire