IKEA RENLIGFWM Manuel d'utilisateur télécharger pdf (Page 25)

When the container is full of water, put

the drainage duct back again and empty

the container. Do steps 3 and 4 again

and again until no more water flows out

from the drain pump.

Pull back the drainage duct.

Unscrew the filter and remove it.

Remove fluff and objects from the pump.

Make sure that the impeller of the pump

can turn. If this

does not occur, contact the service centre.

Clean the filter under the water tap and

put it back in the pump into the special

guides.

Make sure that you tighten correctly the

filter to prevent leakages.

Close the pump door.

Cleaning the water inlet filters

If the appliance takes long to fill with water

or doesn't fill, the starting button indicator

light blinks in red. Check if the water inlet fil-

ters are blocked (see chapter "What to do

if..." for more details).

Proceed as follows:

ENGLISH 25

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 35 36

Pas de commentaire

IKEA RENLIGFWM Manuel d'utilisateur Page 25