IKEA UFC213/18 Manuel d'utilisateur télécharger pdf (Page 6)

• Adequate air circulation should be around

the appliance, lacking this leads to over-

heating. To achieve sufficient ventilation fol-

low the instructions relevant to installation.

• Wherever possible the back of the product

should be against a wall to avoid touching

or catching warm parts (compressor, con-

denser) to prevent possible burn.

• The appliance must not be located close to

radiators or cookers.

• Make sure that the mains plug is accessible

after the installation of the appliance.

Service

• Any electrical work required to do the serv-

icing of the appliance should be carried out

by a qualified electrician or competent per-

son.

• This product must be serviced by the After

Sales Service, and only genuine spare parts

must be used. The service numbers are listed

in the Service information.

Environment Protection

This appliance does not contain gasses which

could damage the ozone layer, in either its re-

frigerant circuit or insulation materials. The ap-

pliance shall not be discarded together with

the urban refuse and rubbish. The insulation

foam contains flammable gases: the appliance

shall be disposed according to the applicable

regulations to obtain from your local authori-

ties. Avoid damaging the cooling unit, espe-

cially at the rear near the heat exchanger. The

materials used on this appliance marked by

the symbol

are recyclable.

Operation

Switching on

Insert the plug into the wall socket.

Turn the temperature regulator clockwise to a

medium setting.

Switching off

To turn off the appliance, turn the temperature

regulator to the "O" position.

Temperature regulation

The temperature is automatically regulated.

To operate the appliance, proceed as follows:

• turn the temperature regulator toward low-

er settings to obtain the minimum coldness.

• turn the temperature regulator toward high-

er settings to obtain the maximum coldness.

A medium setting is generally the most

suitable.

However, the exact setting should be chosen

keeping in mind that the temperature inside

the appliance depends on:

• room temperature

• how often the door is opened

• the quantity of food stored

• the location of the appliance.

Important! If the ambient temperature is high

or the appliance is fully loaded, and the

appliance is set to the lowest temperatures, it

may run continuously causing frost to form on

the rear wall. In this case the dial must be set

to a higher temperature to allow automatic

defrosting and therefore reduced energy

consumption.

ENGLISH 6

1 2 3 4 5 6 7 8 9 10 11 ... 59 60

Commentaires sur ces manuels

Pas de commentaire